Toyota Tacoma (2015-2018) Service Manual: Initialization
INITIALIZATION
1. MAINTENANCE REQUIRED REMINDER RESET PROCEDURE
HINT:
Models with Maintenance Required Reminder Function.
(1) Turn the ignition switch to ON.
(2) Using the steering pad switch assembly, display the setting display on the multi-information display.
(3) Select "Maintenance System" from the setting display and perform initialization according to the multi-information display.
System Diagram
SYSTEM DIAGRAM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptom
are list ...
Other materials:
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Communication Method
Airbag sensor assembly
Main body ECU
Front seat inner belt assembly LH buckle switch
CAN
Combination mete ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(e) Check for DTCs.
2. DTC CLEAR USING TECHSTREAM
(a) Conn ...
Detachable pole antenna
The antenna can be removed.
■ Removing the antenna
Place the included wrench around the antenna.
When not in use, the wrench is stored in glove box.
Loosen the antenna with the wrench and remove it.
■ Installing the antenna
Tighten the antenna by one hand until it will not t ...
