Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repairs" after replacing the spark plug (See page ).
(a) Install the 6 spark plugs.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
2. INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repairs" after replacing the ignition coil assembly (See page ).
(a) Install the 6 ignition coils with the 6 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(b) Connect the 6 connectors to the 6 ignition coil assemblies.
3. INSTALL WIRE HARNESS CLAMP BRACKET
(a) Install the wire harness clamp bracket with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(b) Engage the 2 clamps and connect the wire harness to the wire harness clamp bracket.
4. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
(See page )
2. REMOVE WIRE HARNESS CLAMP BRACKET
(a) Disengage the 2 clamps to disconnect the wire harness from the wire harness clamp bracket. |
|
(b) Remove the bolt and wire harness clamp bracket.
3. REMOVE IGNITION COIL ASSEMBLY
(a) Disconnect the 6 connectors from the 6 ignition coil assemblies.
(b) Remove the 6 bolts and 6 ignition coil assemblies.
4. REMOVE SPARK PLUG
(a) Remove the 6 spark plugs.
Customize Parameters
CUSTOMIZE PARAMETERS
1. CUSTOMIZE FUNCTION WITH TECHSTREAM
NOTICE:
Be sure to record the current settings before customizing.
These buzzers should be ON for safe driving. Perform these procedure
only if it is necessary to turn the buzzer OFF (disabled).
HINT:
The following ...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
HINT:
The tire pressure warning valve and transmitter is powered by a lithium battery.
When disposing of the tire pressure warning valve and transmitter, remove the battery
and dispose of it correctly.
PROCEDURE
1. DISPOSE OF TIRE PRESSURE WARNING VALVE AND ...
Diameter of the Tire is not Uniform (C1337)
DESCRIPTION
The skid control ECU (master cylinder solenoid) measures the speed of each wheel
by receiving signals from the speed sensors. These signals are used for recognizing
whether all 4 wheels are operating properly. Therefore, all wheel signals must be
equal.
DTC No.
...