Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Vacuum Brake Booster) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

(a) Interview the customer and confirm the trouble.

Click here

3.	CHECK DTC AND FREEZE FRAME DATA*

(a) Check and record DTC and Freeze Frame Data.

for DTC Check/Clear: Click here for Freeze Frame Data: Click here

for Freeze Frame Data: Click here (b) Clear the DTC and Freeze Frame Data.

(b) Clear the DTC and Freeze Frame Data.

Click here

(1) Reconfirm the DTC based on the recorded DTC and Freeze Frame Data.

for DTC Check/Clear: Click here for Freeze Frame Data: Click here

for Freeze Frame Data: Click here

HINT:

If DTC U0100, U0124 or U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit.
Click here
If there is no response from the skid control ECU (brake actuator assembly), inspect the +BS circuit of the skid control ECU (brake actuator assembly).
Click here

Result	Proceed to
DTC is output	A
DTC is not output (Problem symptom does not occur)	B
DTC is not output (Problem symptom occurs)	C

GO TO STEP 5

GO TO STEP 6

4.	DIAGNOSTIC TROUBLE CODE CHART

(a) Proceed to Diagnostic Trouble Code Chart.

Click here

GO TO STEP 7

5.	SYMPTOM SIMULATION

(a) Proceed to Check for Intermittent Problems.

Click here

6.	PROBLEM SYMPTOMS TABLE

(a) Proceed to Problem Symptoms Table.

Click here

7.	CIRCUIT INSPECTION*

8.	IDENTIFICATION OF PROBLEM

9.	REPAIR OR REPLACE

10.	CONFIRMATION TEST

END

Check For Intermittent Problems

CHECK FOR INTERMITTENT PROBLEMS 1. CHECK FOR INTERMITTENT PROBLEMS HINT: A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detect ...

Calibration

CALIBRATION 1. DESCRIPTION (a) After replacing any VSC related components or performing wheel alignment adjustment, clear and read the sensor calibration data. Refer to the table below and then p ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY (a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head contacts the cylinder block sub-assembly and manifolds. Text in Illustration *a Intake S ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The ECU stores trouble codes when malfunctions occur. The diagnostic system allows for reading of the trouble codes from the DLC3. Use the Techstream to help diagnose and repair the problem. 2. CHECK DLC3 (a) Check the DLC3 (See page ). 3. INSPECT BATTERY VOLT ...

Utility
UTILITY NOTICE: If the forward recognition camera has been replaced due to a malfunction in the lane departure alert system, be sure to perform Recognition Camera/Target Position Memory and Optical Axis Learning. Otherwise all systems that use the forward recognition camera may be affected. ...