PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
Click here
|
3. |
PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
Click here
|
4. |
DTCs CHECK (Present and Past DTCs) |
Click here
(a) Check for DTCs.
Result |
Proceed to |
---|---|
DTC is output. |
A |
DTC is not output. |
B |
B |
GO TO PROBLEM SYMPTOMS TABLE |
|
5. |
DTCs CHART |
Click here
|
6. |
CIRCUIT INSPECTION |
|
7. |
REPAIR OR REPLACEMENT |
|
8. |
DTC CLEARANCE (Present and Past DTCs) |
Click here
(a) Clear the DTCs.
|
9. |
DTC CHECK (Present and Past DTCs) |
Click here
(a) Check for DTCs.
Result |
Proceed to |
---|---|
DTC is not output. |
A |
DTC is output. |
B |
B |
GO TO STEP 5 |
|
10. |
SYMPTOM SIMULATION |
Click here
(a) Check the passenger airbag ON/OFF indicator condition.
Result |
Proceed to |
---|---|
Passenger airbag ON/OFF indicator is operating normally. |
A |
Passenger airbag ON/OFF indicator (OFF) and SRS warning light come on. |
B |
B |
GO TO STEP 5 |
|
11. |
CONFIRMATION TEST |
NEXT |
END |
Steering Angle Sensor Internal Circuit (C1433)
DESCRIPTION
The skid control ECU (brake actuator assembly) outputs this DTC when it receives
an internal malfunction signal from the steering angle sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1433
St ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disconnect the C27 and C29 certification ECU (smart key ECU assembly) connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side w ...
4wd Control Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL 4 WHEEL DRIVE CONTROL ECU
(a) Engage the 2 guides to install the 4 wheel drive control ECU.
(b) Install the 2 bolts.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
(c) Connect the 2 connectors.
2. INSTALL ...