Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

Toyota Tacoma (2015-2018) Service Manual / Air Conditioning / Air Conditioning System(for Automatic Air Conditioning System) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the air conditioning system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

(a) Inspect the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

3.	CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result	Proceed to
CAN DTCs is not output	A
CAN DTCs is output	B

GO TO CAN COMMUNICATION SYSTEM

4.	CHECK FOR DTC*

(a) Check for DTCs and note any code that is output.

(b) Clear the DTCs.

(c) Recheck for DTCs. Based on the DTCs output above, try to force the air conditioning system to output DTCs by simulating the conditions indicated by the DTC.

Result	Proceed to
DTCs is not output	A
DTCs is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

5.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO STEP 7

6.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Panel diagnosis (indicator check, sensor check)

Click here (b) Data List / Active Test

(b) Data List / Active Test

Click here (c) Terminals of ECU

Click here (d) On-vehicle Inspection

(d) On-vehicle Inspection

(e) Inspection

7.	ADJUST, REPAIR OR REPLACE

END

Customize Parameters

CUSTOMIZE PARAMETERS PROCEDURE 1. CUSTOMIZE AIR CONDITIONING SYSTEM (a) Customizing with the Techstream NOTICE: When the customer requests a change in a function, first make sure that ...

System Description

SYSTEM DESCRIPTION 1. GENERAL (a) The air conditioning system has the following controls. Control Outline Neural Network Control This control is ca ...

Other materials:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs. 2. CHECK DLC3 (a) Check ...

System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU (Transmitter) Receiving ECU (Receiver) Signal Line Certification ECU (Smart Key ECU Assembly) Main Body ECU (Multiplex Network Body ECU) ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be then read. (b) ...