Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE
Click here
2. REMOVE HIGH PITCHED HORN ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Remove the bolt and high pitched horn assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT HIGH PITCHED HORN ASSEMBLY
(a) Check the operation.
|
(1) Apply battery voltage to the terminal 1 and body ground, and check that the high pitched horn assembly sounds. Text in Illustration
OK:
If the result is not as specified, replace the high pitched horn assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL HIGH PITCHED HORN ASSEMBLY
(a) Install the high pitched horn assembly with the bolt.
Torque:
20 N·m {199 kgf·cm, 14 ft·lbf}
(b) Connect the connector.
2. INSTALL RADIATOR GRILLE
Click here
Horn
Horn RelayHow To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Perform the following procedure to troubleshoot the dynamic radar cruise
control system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION
This DTC is stored when there is a malfunction in the ECM.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
P057504
Cruise Control System Internal Failure
While the dynamic rada ...
Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
DESCRIPTION
Refer to DTCs C1403 and C1404 (See page ).
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1407
Open or Short in Rear Speed Sensor RH Circuit
Either of the following is detected:
...