Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Headlight Dimmer Relay

Inspection

INSPECTION

PROCEDURE

1. INSPECT HEADLIGHT DIMMER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace, the headlight dimmer relay.

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL CLEARANCE LI ...

Headlight Dimmer Switch
...

Other materials:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Perform the following procedure to troubleshoot the dynamic radar cruise control system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows t ...

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). HINT: Use the same procedure for both the RH and LH sides. The procedure describe ...

© 2011-2024 Copyright www.ttguide.net