Toyota Tacoma (2005–2015) Owners Manual: Front seats
Bench type seat
Seat position adjustment lever
Separated type seats
Seat position adjustment lever
Driver’s seat lumbar support adjustment
knob (if equipped)
Seatback angle adjustment lever
- Moving passenger’s seat for rear seat entry (if equipped)
- Folding seatback (Bench type seat)
- Folding passenger’s seat (vehicles with seatback table)
- Active head restraints (Access Cab and Double Cab models only)
Moving passenger’s seat for rear seat entry (if equipped)
Lift the seatback angle adjusting lever or press the pedal behind the seatback.
The seat will slide forward.
Move the seat to the front-most position.
■ After passengers are in the vehicle ...
Other materials:
Detecting Vehicle Submersion (B2277)
DESCRIPTION
This DTC is stored when a malfunction in the water submersion detection circuit
in the certification ECU (smart key ECU assembly) is detected.
HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal,
the power source mode returns to the state it w ...
Terminals Of Ecu
TERMINALS OF ECU
FORWARD RECOGNITION CAMERA
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the Techstream once the inspection
has been completed.
Do not apply excessive force to the forward recognition ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DRIVE SHAFT
(a) Coat the spline of the inboard joint shaft with gear oil.
(b) Align the shaft splines and install the front drive shaft with a brass bar
and hammer.
NOTICE:
Set the snap ring with the opening side facing downward.
Be caref ...
