Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Front Radar Sensor (C1A10)

DESCRIPTION

C1A10 is output when there is an internal malfunction in the millimeter wave radar sensor assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

C1A10

Front Radar Sensor

While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the internal malfunction of the millimeter wave radar sensor assembly continues for 0.3 seconds or more.

Millimeter wave radar sensor assembly

Does not come on

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle, and as a result, a DTC may be stored.
  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

PROCEDURE

1.

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly with a new one.

Click here (b) Perform millimeter wave radar sensor assembly adjustment.

(b) Perform millimeter wave radar sensor assembly adjustment.

Click here

NEXT

2.

CLEAR FOR DTCs (RADAR CRUISE 2)

(a) Clear the DTCs.

Click here

NEXT

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

Brake Switch "A" Circuit Open (P057113)
DESCRIPTION When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 operates the ...

Front Radar Sensor Incorrect Axial Gap (C1A11,C1A14)
DESCRIPTION When the system determines that the vehicle is driving straight ahead based on signals from the yaw rate and acceleration sensor (airbag sensor assembly), etc., the millimeter wave ra ...

Other materials:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL INSTRUMENT PANEL CUSHION (a) Install a new instrument panel cushion as shown in the illustration. Text in Illustration *a R End *b 25 to 45 mm (0.984 to 1.772 in.) ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before pr ...

В© 2011-2024 Copyright www.ttguide.net