Inspection
INSPECTION
PROCEDURE
1. INSPECT COOLER THERMISTOR SENSOR
(a) Check the resistance.
(1) Measure the resistance and check the results in accordance with the values in the table below. Standard:
If the result is not as specified, replace the cooler thermistor sensor. NOTICE:
HINT: As the temperature increases, the resistance decreases (see the graph on the left). |
|
Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422,C1456)
DESCRIPTION
Refer to DTCs C1421, C1423, C1424, C1455, C1457 and C1458 (See page
).
DTC Code
DTC Detection Condition
Trouble Area
C1422
When the stop light switch is off, the PM/C1 terminal voltage is 0.86
V or higher for 5 seconds ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See page
).
HINT:
Use the same procedure for both the RH and LH sides.
The procedure des ...
Mirror Heater does not Operate with Rear Defogger Switch
DESCRIPTION
When the mirror heater switch on the air conditioning control assembly is pressed,
the operation signal is sent to the air conditioning amplifier assembly. When the
air conditioning amplifier assembly receives the signal, it turns on a relay in
the air conditioning amplifier assem ...