Toyota Tacoma (2015-2018) Service Manual: Freeze Frame Data
FREEZE FRAME DATA
1. FREEZE FRAME DATA
(a) Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.
2. CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
(e) According to the Techstream display, select a DTC that stored freeze frame data.
(f) Read the freeze frame data recorded when the DTC was stored.
Combination Meter|
Tester Display |
Condition |
Displayed Item |
|---|---|---|
|
B1507 |
Open in Turn Signal Circuit |
|
|
B1508 |
Short in Turn Signal / Hazard Flasher Circuit |
|
|
B150A |
Lost Communication with HMI-LAN |
|
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
|
U0129 |
Lost Communication with Brake System Control Module |
|
|
U0142 |
Lost Communication with Body Control Module "B" |
|
|
U0151 |
Lost Communication with Restraints Control Module |
|
|
U0163 |
Lost Communication with Navigation Control Module |
|
|
U023A |
Lost Communication with Front Camera Module |
|
|
U1104 |
Lost Communication with Driving Support ECU |
3. CLEAR FREEZE FRAME DATA
CAUTION:
Clearing the DTCs will also clear the freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Clear DTCs and freeze frame data.
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Trouble Cod ...
Lost Communication with HMI-LAN (B150A)
DESCRIPTION
The combination meter assembly receives a text data signal from the navigation
receiver assembly or radio and display receiver assembly via local bus communication.
Based on this signa ...
Other materials:
Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION
The occupant classification ECU detects the state of the front seat inner belt
assembly RH and load sensor when the front passenger side seat is occupied with
the ignition switch ON. If the front passenger side seat belt is not fastened, the
front passenger side seat belt warning ...
Test Mode Procedure
TEST MODE PROCEDURE
1. TEST MODE PROCEDURE (for Using Techstream)
HINT:
If the ignition switch is turned from the ON to the ACC or LOCK position
during test mode, DTCs related to the signal check function will be cleared.
During test mode, the skid control ECU (master cylinder ...
Front Left Seat Heat Sensor Circuit (B14C1)
DESCRIPTION
Output to the front seat cushion heater assembly LH temperature sensor stops
if one of the following occurs: 1) the temperature sensor is open or shorted; or
2) the temperature sensor is damaged and its output value does not change.
DTC Code
DTC Detection Cond ...
