Toyota Tacoma (2005–2015) Owners Manual: Folding seatback (Bench type seat)
Pull the seatback lock release lever and fold down the seatback.
Hold the lever until you have swung the seatback forward slightly.
Moving passenger’s seat for rear seat entry (if equipped)
Lift the seatback angle adjusting lever or press the pedal behind the seatback.
The seat will slide forward.
Move the seat to the front-most position.
■ After passengers are in the vehicle ...
Folding passenger’s seat (vehicles with seatback table)
Pull the seatback angle adjusting lever and raise the seatback to its upright
position.
Pull the seatback folding lever and fold the seatback down. ...
Other materials:
Terminals Of Ecu
TERMINALS OF ECU
1. CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the C30 connector from the clearance warning ECU assembly.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wiring Color
Terminal Descr ...
Brake Warning Light Remains ON
DESCRIPTION
The BRAKE warning light comes on when brake fluid is insufficient, the parking
brake is applied or the EBD is defective.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform
calibration (See page
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Using a dial indicator, check the propeller shaft runout.
Maximum runout:
0.6 mm (0.0236 in.)
If the shaft runout is greater than the maximum, replace the shaft.
2. INSPECT PROPELLER SHAFT
(a) Using a dial ...
