Toyota Tacoma (2015-2018) Service Manual: Fail-safe Chart
FAIL-SAFE CHART
1. FAIL-SAFE OPERATION AND DEACTIVATION CONDITION
DIFFERENTIAL SYSTEM (w/ Differential Lock)|
DTC No. |
Fail-safe Operation |
Fail-safe Deactivation Condition |
|---|---|---|
|
U0122 |
All switching prohibited When rear differential is locked, rear differential switches to free |
CAN communication signal from skid control ECU is received and ignition switch is turned from off to ON |
|
U0416 |
for 4WD: Switching from 2WD to H4 and rear differential free to locked prohibited When rear differential is locked, rear differential switches to free for 2WD: Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Wheel speed sensor malfunction signals from skid control ECU return to normal and ignition switch is turned from off to ON |
|
P163B |
for 4WD: Switching from 2WD to H4 and rear differential free to locked prohibited When rear differential is locked, rear differential switches to free for 2WD: Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
4 wheel drive control ECU internal circuit returns to normal and ignition switch is turned from off to ON |
|
P17BB |
Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Differential lock indicator switch signal returns to normal and ignition switch is turned from off to ON |
|
P17BC |
Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Differential lock indicator switch signal returns to normal and ignition switch is turned from off to ON |
|
P17C0 |
Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Differential lock coil drive circuit of rear differential recovers from ground short and ignition switch is turned from off to ON |
|
P17C1 |
Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Differential lock coil drive circuit of rear differential recovers from battery short and ignition switch is turned from off to ON |
|
P17CC |
Switching from rear differential free to locked prohibited When rear differential is locked, rear differential switches to free |
Differential lock switch signal returns to normal and ignition switch is turned from off to ON |
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Check the DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) ...
Freeze Frame Data
FREEZE FRAME DATA
1. FREEZE FRAME DATA
(a) When a DTC is stored, the 4 wheel drive control ECU stores the current vehicle
state as Freeze Frame Data.
HINT:
Freeze Frame Data at the time a DTC is ...
Other materials:
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE RADIATOR GRILLE
(See page )
5. REMOVE V-BANK COVER SUB-ASSEMBLY
6. REMOVE RADIATOR SUPPORT TO FRAME SEAL
7. R ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If a normal code is displayed during the DTC check but the problem still occurs,
check the circuits for each problem symptom in the order given in the table below
and proceed to the relevant troubleshooting page.
NOTICE:
When replacing the skid control ECU (master cylin ...
Slip Indicator Light does not Come ON
DESCRIPTION
Refer to Slip Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point
calibration and store system informatio ...
