Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below. Text in Illustration
Standard Resistance:
If the results are not as specified, replace the hood courtesy switch (hood lock assembly). |
|
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
(See page )
2. REMOVE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
(a) Disconnect the connector. |
|
(b) Disengage the clamp to separate the wire harness.
(c) Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap. Text in Illustration
|
|
(d) Remove the 3 bolts to separate the hood courtesy switch (hood lock assembly). |
|
(e) Disengage the guide to disconnect the hood lock control cable assembly and remove the hood courtesy switch (hood lock assembly). |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
(a) Apply MP grease to the sliding areas of the hood courtesy switch (hood lock assembly). |
|
(b) Engage the guide to connect the hood lock control cable assembly.
(c) Install the hood courtesy switch (hood lock assembly) with the 3 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(d) Install a new hood lock nut cap.
(e) Connect the connector.
(f) Engage the clamp to install the wire harness.
2. ADJUST HOOD SUB-ASSEMBLY
(See page )
3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
(See page )
Evaporator Temperature Sensor Circuit (B1413/13)
DESCRIPTION
The cooler thermistor sensor (evaporator temperature sensor) is installed on
the evaporator in the air conditioner unit to detect the temperature of the cooled
air that has passed through the evaporator and is used to control the air conditioning.
It sends signals to the air condi ...
Air Conditioning Compressor Magnetic Clutch Circuit
DESCRIPTION
When the air conditioning amplifier assembly is turned on, a magnetic clutch
on signal is sent from the MGC terminal of the air conditioning amplifier assembly.
Then, the MG CLT relay turns on to operate the magnetic clutch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NO ...
Engine Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected
(Engine Switch)
-
...