Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: ECM Communication Circuit Malfunction (C1203)

DESCRIPTION

The circuit sends TRAC, A-TRAC and VSC control information from the skid control ECU (master cylinder solenoid) to the ECM, and engine control information from the ECM to the skid control ECU (master cylinder solenoid) via the CAN communication system.

DTC Code

DTC Detection Condition

Trouble Area

C1203

Information relating to engine drive source or destination stored in ECM does not match that stored in skid control ECU (master cylinder solenoid).

  • CAN communication system
  • ECM

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page OK: OK: ).

OK:

CAN Bus Check indicates no malfunctions in CAN communication.

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

OK

2.

CHECK DTC (SFI SYSTEM)

(a) Check if any DTC is recorded for the SFI system (See page Result ).

Result

Result

Proceed to

DTC is output

A

DTC is not output

B

A

GO TO SFI SYSTEM

B

REPLACE ECM

Open in ABS Solenoid Relay Circuit (C146E,C146F)
DESCRIPTION The ABS solenoid relay is built into the master cylinder solenoid. This relay supplies power to each ABS solenoid. After the ignition switch is turned ON, if the initial check is OK, t ...

Center Differential Lock Position Switch (C1282)
DESCRIPTION DTC C1282 is stored only in test mode. DTC Code DTC Detection Condition Trouble Area C1282 Stored during test mode. ...

Other materials:

USB Device Malfunction (B1585)
DESCRIPTION This DTC is stored when a malfunction occurs in a connected device. DTC No. DTC Detection Condition Trouble Area B1585 USB Device Malfunction Non mass-storage class or incompatible protocol USB device ...

Initialization not Completed (C2177/77)
DESCRIPTION Initialization is necessary if one of the following occurs: The tire pressure warning ECU and receiver is replaced. A tire pressure warning valve and transmitter is replaced. Tires with different standard tire pressures are installed. The tires are rotated. A new ...

Precaution
PRECAUTION 1. PRECAUTIONS FOR REFRIGERANT HFO-1234yf (R1234yf) (a) Compatibility (1) The parts used in the refrigerant cycle, the compressor oil, etc. of the HFO-1234yf (R1234yf) system are not compatible with the conventional HFC-134a (R134a) system. (b) HFO-1234yf (R1234yf) Refrigerant (1 ...

В© 2011-2024 Copyright www.ttguide.net