DISASSEMBLY
PROCEDURE
1. REMOVE ROOM LIGHT BRACKET
(a) Disengage the guide to remove the room light bracket. |
|
2. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
(a) Remove the 2 bolts and sliding roof drive gear sub-assembly. |
|
3. REMOVE SUNSHADE TRIM SUB-ASSEMBLY
(a) Remove the screw. |
|
(b) Disengage the claw and 2 guides to remove the sliding roof drain hose joint LH as shown in the illustration.
(c) Remove the screw. |
|
(d) Disengage the claw and 2 guides to remove the sliding roof drain hose joint RH as shown in the illustration.
(e) Slide and remove the sunshade trim sub-assembly as shown in the illustration. |
|
4. REMOVE ROOF DRIP CHANNEL
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws. Text in Illustration
|
|
(b) Slide and remove the roof drip channel as shown in the illustration. |
|
5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY LH
NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the sliding roof guide block. Text in Illustration
|
|
(b) Remove the sliding roof drive cable sub-assembly LH.
6. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
FCM Destination Information Unmatched (C1AA1)
DESCRIPTION
When the forward recognition camera is replaced with a new one, the new forward
recognition camera attempts to store country specification information received
from the main body ECU (multiplex network body ECU) and ECM. If the country specification
information stored in the forwa ...
Accelerator Pedal
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / En ...
Transponder Chip Malfunction (B2793,B2794,B2797,B2798)
DESCRIPTION
DTC B2793 is stored when a malfunction is found in the key during key
code registration or a key code is not registered normally. Replace the
key if key code registration cannot be performed normally and this DTC is
output.
DTC B2794 is stored when a key with an i ...