DISASSEMBLY
PROCEDURE
1. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Put matchmarks on the steering intermediate shaft assembly and steering main shaft assembly.
(b) Remove the bolt and steering intermediate shaft assembly.
2. REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Smart Key System)
(a) Secure the steering column assembly in a vise between aluminum plates.
NOTICE:
Do not overtighten the vise.
(b) Using a drill, drill a hole in the tapered-head bolt and insert a screw extractor.
(c) Using the screw extractor, remove the tapered-head bolt and upper steering column bracket with switch assembly.
3. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Smart Key System)
HINT:
Perform the same procedure as for the upper steering column bracket with switch assembly.
4. REMOVE TRANSPONDER KEY AMPLIFIER (w/o Smart Key System)
(a) Disengage the 2 claws to remove the transponder key amplifer.
5. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Smart Key System)
(a) Remove the 2 screws and ignition or starter switch assembly from the upper steering column bracket assembly.
6. REMOVE KEY INTER LOCK SOLENOID (for Automatic Transmission without Smart Key System)
(a) Remove the screw.
(b) Disengage the claw to remove the key interlock solenoid from the upper steering column bracket assembly.
7. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System)
(a) Turn the ignition switch to ACC.
(b) Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and pull the ignition switch lock cylinder assembly.
Text in Illustration
Push |
|
Pull |
(c) Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly and tilt it upward, as shown in the illustration, to disengage the claw on the ignition switch lock cylinder assembly. Then pull out the ignition switch lock cylinder assembly.
Text in Illustration
*a |
Claw |
Tilt |
|
Pull |
HINT:
When the ignition switch lock cylinder assembly disengages, a click sound is heard.
8. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System)
(a) Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws. Text in Illustration
HINT: Slide the un-lock warning switch in the direction shown by the arrow in the illustration to remove it. |
|
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine ...
Speaker Circuit
DESCRIPTION
If there is a short in a speaker circuit, the stereo component amplifier assembly*1
or navigation receiver assembly*2 detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction
in the stereo component amplifier assembly ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR BUMPER ASSEMBLY
(a) Using an engine lifter or equivalent, engage the 2 pins to install the rear
bumper assembly as shown in the illustration.
Text in Illustration
*a
Pin
-
-
NOTICE:
Using pl ...