DISASSEMBLY
PROCEDURE
1. REMOVE REAR AXLE SHAFT SNAP RING
(a) Using a snap ring expander, remove the snap ring.
2. REMOVE REAR AXLE SHAFT
(a) Using SST and press, remove the rear axle shaft.
SST: 09521-25011
SST: 09521-25021
3. REMOVE REAR AXLE BEARING RETAINER INNER
(a) Remove the rear axle bearing retainer inner from the rear axle bearing.
4. REMOVE REAR AXLE SHAFT WASHER
(a) Remove the rear axle shaft washer from the rear axle bearing.
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Attach the 4 nuts to the rear axle housing bolts.
(b) Using a hammer, remove the 4 rear axle housing bolts and rear axle bearing.
NOTICE:
Do not reuse the nuts previously removed from the vehicle.
6. REMOVE REAR AXLE HUB BOLT
(a) Using SST, remove the 6 hub bolts. SST: 09650-17011 |
|
(b) Remove the deflector and deflector gasket from the rear axle shaft.
7. REMOVE REAR AXLE BEARING OIL SEAL
(a) Grind the rear axle bearing inner race surface using a grinder, and then chisel them out with a chisel.
(b) Remove the rear axle shaft oil seal from the rear axle shaft.
Illumination for Panel Switch does not Come on with Tail Switch ON
PROCEDURE
1.
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal
in Operation Check (See page ).
(b) Check that the display changes between ON and OFF according to the light
control ...
Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION
The navigation receiver assembly sends a sound signal to the stereo component
amplifier assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier
assembly, and then is sent to the speakers.
If there is an open or short in the cir ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 FUEL TANK PROTECTOR
(a) Install the No. 1 fuel tank protector to the fuel tank assembly with the
4 clips.
2. INSTALL FUEL SUCTION TUBE SET GASKET
Click here
3. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here
4. INSTALL FUEL PUMP ...