DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" below.
Transponder Key ECU Assembly
DTC Code |
Detection Item |
See page |
---|---|---|
B2780 |
Push Switch / Key Unlock Warning Switch Malfunction |
|
B2784 |
Antenna Coil Open / Short |
|
B2793 |
Transponder Chip Malfunction |
|
B2794 |
Unmatched Encryption Code |
|
B2797 |
Communication Malfunction No. 1 |
|
B2798 |
Communication Malfunction No. 2 |
|
HINT:
The DTCs for the engine immobiliser system are specified below. If other codes are output, check the DTC chart for the SFI system.
ECM
DTC Code |
Detection Item |
See page |
---|---|---|
B2799*1 |
Engine Immobiliser System Malfunction |
|
B279986*2 |
Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid |
|
B279A*1 |
Theft Deterrent System Communication Line High Fixation |
|
B279A12*2 |
Engine Immobiliser System Circuit Short to Battery |
|
B279C*1 |
Theft Deterrent System Presence Detection |
|
B279C95*2 |
Engine Immobiliser System Incorrect Assembly |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT AXLE HUB
2. INSTALL FRONT SUSPENSION UPPER ARM
(a) Install a new nut and clip.
Torque:
110 N·m {1122 kgf·cm, 81 ft·lbf}
3. INSTALL FRONT SUSPENSION LOWER ARM
(a) Install the front suspension lower arm with the 2 bolts.
Torque:
160 N·m {1631 ...
Steering Angle Sensor (C1A47)
DESCRIPTION
The millimeter wave radar sensor assembly receives steering angle information
from the steering angle sensor (spiral cable with sensor sub-assembly). If the millimeter
wave radar sensor assembly detects a steering angle sensor (spiral cable with sensor
sub-assembly) malfunction, D ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE INTAKE VALVE
(a) Using SST, compress the inner compression spring and remove the valve
spring retainer locks.
SST: 09202-70020
SST: 09202-00021
09202-01010
09202-01020
(b) Remove the valve s ...