DEFINITION OF TERMS
Term |
Definition |
---|---|
Monitor description |
Description of what the ECM monitors and how it detects malfunctions (monitoring purpose and details). |
Related DTCs |
Group of diagnostic trouble codes that are output by the ECM based on the same malfunction detection logic. |
Typical enabling condition |
Preconditions that allow the ECM to detect malfunctions. With all preconditions satisfied, the ECM stores a DTC when the monitored value(s) exceeds the malfunction threshold(s). |
Sequence of operation |
The priority order that is applied to monitoring if multiple sensors and components are used to detect the malfunction. While one sensor is being monitored, the next sensor or component will not be monitored. |
Required sensor / Components |
The sensors and components that are used by the ECM to detect malfunctions. |
Frequency of operation |
The number of times that the ECM checks for malfunctions per driving cycle. "Once per driving cycle" means that the ECM detects a malfunction only once during a single driving cycle. "Continuous" means that the ECM detects a malfunction every time the enabling conditions are met. |
Duration |
The minimum time for which the ECM must detect a continuous deviation in the monitored value(s) in order to store a DTC. Timing begins after the "typical enabling conditions" are met. |
Typical malfunction thresholds |
Value beyond which the ECM will determine that there is a malfunction and store a DTC. |
MIL operation |
MIL illumination timing after a malfunction is detected. "Immediate" means that the ECM illuminates the MIL the instant the ECM determines that there is a malfunction. "2 driving cycles" means that the ECM illuminates the MIL if the same malfunction is detected again in the next driving cycle. |
Component operating range |
Normal operation range of sensors and solenoids under normal driving conditions. Use these ranges as a reference. They cannot be used to judge if a sensor or solenoid is defective or not. |
Components
COMPONENTS
ILLUSTRATION
HINT:
The following specifications are for BD22AN (w/ Differential Lock). BD22AN differentials
are equipped with M10 rear differential carrier to rear axel housing fasteners.
ILLUSTRATION
ILLUSTRATION
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Smart Key System
DTC Code
Detection Item
See page
B27A1
Open in Driver Side Electrical Antenna Circuit
B27A5
Open in Front Floor Electrical Key Oscillator Circuit
...
Registered Device cannot be Deleted
PROCEDURE
1.
DELETE OPERATION
(a) Check if a registered portable player can be deleted normally.
OK:
Registered portable player can be deleted normally.
OK
END
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYM ...