DEFINITION OF TERMS
Term |
Definition |
---|---|
Monitor Description |
Description of what the ECM monitors and how it detects malfunctions (monitoring purpose and details). |
Related DTCs |
A group of diagnostic trouble codes that are output by the ECM based on the same malfunction detection logic. |
Typical Enabling Conditions |
Preconditions that allow the ECM to detect malfunctions. With all preconditions satisfied, the ECM stores a DTC when the monitored value(s) exceeds the malfunction threshold(s). |
Sequence of Operation |
Order of monitor priority, applied if multiple sensors and components are involved in a single malfunction detection process. Each sensor and component is monitored in turn and subsequent items are not monitored until the previous detection operation completes. |
Required Sensors/Components |
Sensors and components used by the ECM to detect each malfunction. |
Frequency of Operation |
Number of times the ECM checks for each malfunction during each driving cycle. "Once per driving cycle" means that the ECM only checks for malfunctions once during a single driving cycle. "Continuous" means that the ECM checks for malfunctions whenever enabling conditions are met. |
Duration |
Minimum time for which the ECM must detect continuous deviation in monitored value(s) in order to store a DTC. Timing begins when typical enabling conditions are met. |
Typical Malfunction Thresholds |
Value beyond which the ECM will determine that there is a malfunction and store a DTC. |
MIL Operation |
Timing of MIL illumination after a malfunction is detected. "Immediate" means that the ECM illuminates the MIL as soon as a malfunction is detected. "2 driving cycles" means that the ECM illuminates the MIL if the same malfunction is detected again during the next driving cycle. |
Rear Leaf Spring
Components
COMPONENTS
ILLUSTRATION
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BUSH
(a) Fix the spring in a vise.
(b) Using a hack saw, cut both ends off the bushes.
(c) Using SST and a press, press out the 2 bushes.
SST: 09950-60010
09951-00350
SST: 09950-70010
...
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock assembly.
The hood and hood lock assembly cannot be adjusted with the centering bolts
installed. Substitute the centering bolts with standard bolts when making
adjustments ...
Removal
REMOVAL
PROCEDURE
1. REMOVE MILLIMETER WAVE RADAR WIRE
(a) for Type A:
(1) Disconnect the 2 connectors.
(2) Using a clip remover, disengage the 4 clamps to remove the millimeter
wave radar wire.
(b) for Type B:
(1) Disc ...