DESCRIPTION
This DTC is stored when there is a malfunction in the ECM.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
---|---|---|---|---|
P057504 |
Cruise Control System Internal Failure |
While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM. |
ECM |
Does not come on |
P057549 |
Cruise Control Internal Electronic Failure |
While the dynamic radar cruise control system is operating, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more. |
ECM |
Does not come on |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the ECM, refer to Registration.
w/o Smart Key System: Click here
w/ Smart Key System: Click here
HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch is turned off.
PROCEDURE
1. |
CHECK FOR DTCs |
(a) Clear the DTCs.
Click here
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
(c) Check for DTCs.
Click here
OK:
DTC P057504 and P057549 are not output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE ECM |
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows t ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Hydraulic Brake Booster
*B
for Vacuum Brake Booster
*1
FORWARD RECOGNITION CAMERA
*2
MILLIMETER WAVE RADAR SENSOR ASSEMBLY
*3
HYDRAULIC BRA ...
Oil Level Sensor
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condi ...