DESCRIPTION
This DTC is stored when there is a malfunction in the ECM.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
P0575 |
Cruise Control Input Circuit |
Either of the following conditions is met:
|
ECM |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the ECM, refer to Registration.
w/o Smart Key System: Click here
w/ Smart Key System: Click here
HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.
PROCEDURE
1. |
CHECK FOR DTCs (RADAR CRUISE1) |
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(c) Check for DTCs.
Click here
Result |
Proceed to |
---|---|
DTC P0575 are not output. |
A |
DTC P0575 are output. |
B |
A |
USE SIMULATION METHOD TO CHECK |
B |
REPLACE ECM |
Tire Pressure Warning Light Circuit
DESCRIPTION
If the tire pressure warning ECU and receiver detects any problems, the tire
pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring
is disabled at the same time. At this time, the ECU stores a DTC in memory.
Connecting terminals TC and CG of the D ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT TECHSTREAM
(a) Warm up the engine.
(b) Turn the ignition switch to off.
(c) Connect the Techstream to the DLC3.
(d) Turn the ignition switch to ON.
(e) Turn the Techstream on.
(f) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
2. ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL FOG LAMP ASSEMBLY
(a) Engage the 2 guides to install the fog light assembly.
(b) Install the screw.
(c) Con ...