The switch allows the vehicle to be driven out of difficult situations by cranking the engine with the clutch engaged.
Never use the switch for normal engine starting. Be sure to follow the starting procedure.
Press the CLUTCH START CANCEL switch to cancel the clutch start system when the engine switch is turned to the ON position.
The indicator comes on when the clutch start system is canceled.
The clutch start cancel switch is automatically turned off when the engine switch is turned off.
■Clutch start system
The system is designed to keep the starter motor from operating if the clutch pedal is not depressed all the way down.
Access doors (Access Cab models only)
The access door (rear door) can be opened using the inside handle.
Open the front door widely
Pull (from the outside) or push
(from the inside) the inside handle of the access door.
Open the access door
You can open and close the access door only when the front door is widely opened.
NOT ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 ULTRASONIC SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected:
(No. 1 Ultrasonic Sensor)
Standar ...
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE STRAIGHT PIN
NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.
(a) Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
Text in Illustration
*A
Front Side
*B
...