PROCEDURE
1. |
CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) |
(a) Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.
OK:
The fan of the generator rotor assembly is operating.
NG |
REPLACE GENERATOR PULLEY WITH CLUTCH |
|
2. |
CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION) |
(a) Remove the generator assembly (See page ).
(b) Check the installation condition of the generator pulley cap.
OK:
The generator pulley cap is not loose or missing.
(c) Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).
OK:
No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).
(d) Check the generator with clutch pulley for misalignment (interference with the generator assembly).
OK:
The generator pulley with clutch is correctly aligned (no interference with the generator assembly).
(e) Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise. OK: Noise does not occur when turned in both directions. |
|
(f) Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.
OK:
The generator pulley with clutch does not have runout.
(g) Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise. |
|
OK:
The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
OK |
REPAIR OR REPLACE GENERATOR ASSEMBLY |
NG |
REPLACE GENERATOR PULLEY WITH CLUTCH |
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION
The radio and display receiver assembly and telephone microphone assembly are
connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
DTC Code
DTC Det ...
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
1.
REPLACE CD AND RECHECK
(a) Replace the CD with a known good one and recheck.
(1) Check if the same malfunction occurs again.
OK:
Malfunction disappears.
OK
END
NG
REPLACE NAVIGATION RECEIVER ASSEMBLY ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL CENTER STOP LIGHT ASSEMBLY (for Bulb Type Stop Light)
(a) Install the 3 center stop light bulbs to the 3 center stop light sockets.
(b) Turn the 3 center stop light sockets with 3 center stop light bulbs
in the direction indicated by the arrow sho ...