PROCEDURE
1. |
CHECK IF A PROPER CD IS INSERTED |
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
CD is normal.
HINT:
NG |
CD IS FAULTY |
|
2. |
CHECK THAT CD IS INSERTED PROPERLY |
(a) Check whether or not the CD is inserted upside down.
OK:
CD is properly inserted.
NG |
SET CD PROPERLY |
|
3. |
CLEAN CD AND RECHECK |
(a) Disc cleaning (1) If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. OK: Malfunction disappears. NOTICE: Do not use a conventional record cleaner or anti-static preservative. |
|
OK |
END (CD WAS DIRTY) |
|
4. |
REPLACE CD AND RECHECK |
(a) Replace CD with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK |
CD WAS FAULTY |
NG |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly
to the radio and display receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using
the steering pad switch assembly.
If there is a short in the circuit, the same con ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
(a) Apply the parking brake.
(b) Turn the ignition switch to ON.
(c) Depress the brake pedal and move the shift lever to any position other than
P.
(d) Depress the brake pedal and check that the engine starts when the sh ...
Test Mode Procedure
TEST MODE PROCEDURE
1. TEST MODE PROCEDURE (for Using Techstream)
HINT:
If the ignition switch is turned from the ON to the ACC or LOCK position
during test mode, DTCs related to the signal check function will be cleared.
During test mode, the skid control ECU (master cylinder ...