PROCEDURE
|
1. |
CHECK OPERATION |
(a) Press the disc eject switch of the navigation receiver assembly for 5 seconds or more and check that the CD is ejected.
OK:
CD is ejected.
| NG | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
|
|
2. |
REPLACE CD AND RECHECK |
(a) Replace CD with a known good one and check that the malfunction disappears.
OK:
CD is ejected.
| OK | |
CD WAS FAULTY |
| NG | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
CD cannot be Inserted / Played or CD is Ejected Right After InsertionRemoval
REMOVAL
PROCEDURE
1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Place matchmarks on the propeller shaft flange yoke and differential
flange.
Text in Illustration
*a
Matchmark
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnec ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Proceed to the troubleshooting for each circuit in the table below.
Symptom
Suspected Area
See page
Passenger seat occupant conditions and displayed passenger airbag ON/OFF
indicator do not correspond
Tr ...