DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
---|---|---|
Blind Spot Monitor Sensor Communication Stop Mode |
Either Condition is met:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
CAUTION:
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
NOTICE:
Click here
Click here
Click here
DTC check procedure: Turn the ignition switch to ON and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.
Click here
HINT:
PROCEDURE
1. |
CHECK FOR OPEN IN CAN BUS LINES (BLIND SPOT MONITOR SENSOR LH CAN BRANCH LINE) |
(a) Disconnect the cable from the negative (-) battery terminal. |
|
(b) Disconnect the blind spot monitor sensor LH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
B12-2 (CA1P) - B12-7 (CA1N) |
Cable disconnected from negative (-) battery terminal |
54 to 69 Ω |
*a |
Front view of wire harness connector (to Blind Spot Monitor Sensor LH) |
NG |
REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (BLIND SPOT MONITOR SENSOR LH) |
|
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
(b) Connect the cable to the negative (-) battery terminal.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
B12-5 (BLB) - Body ground |
Ignition switch ON |
11 to 14 V |
*a |
Front view of wire harness connector (to Blind Spot Monitor Sensor LH) |
OK |
REPLACE BLIND SPOT MONITOR SENSOR LH |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Rear Speed Sensor RH Output Malfunction (C1415,C1416)
DESCRIPTION
Refer to DTCs C1403 and C1404 (See page ).
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1415
Rear Speed Sensor RH Output Malfunction
Any of the following is detected:
An op ...
Rear Door(for Access Cab)
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
Centering bolts are used to mount the door hinge to the vehicle body
and door. The door cannot be adjusted with the ce ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Proceed to the troubleshooting for each circuit in the table below.
Symptom
Suspected Area
See page
Passenger seat occupant conditions and displayed passenger airbag ON/OFF
indicator do not correspond
Tr ...