DESCRIPTION
If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.
HINT:
This symptom may occur for any of the windows.
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
PERFORM INITIALIZATION (APPLICABLE LOCATION) |
(a) Initialize the power window regulator motor assembly (applicable location) (See page ).
|
2. |
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION)) |
(a) Check that all door power windows move when the auto up/down function of the multiplex network master switch assembly and power window regulator switch assembly (for front passenger, rear LH and rear RH sides) is operated (See page ).
OK:
Auto up/down function is normal (applicable location).
OK |
END (PROBLEM DUE TO INITIALIZATION FAILURE) |
|
3. |
CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION) |
(a) Remove the window regulator.
(b) Install the window glass onto the door glass run.
(c) Check if the door window regulator operates smoothly.
(d) Check that the window glass slides smoothly when sliding it up by hand.
OK:
Door window glass slides smoothly.
CAUTION:
Perform initialization again.
HINT:
Ensure the following:
Result |
Proceed to |
---|---|
NG |
A |
OK (Driver side power window) |
B |
OK (Front passenger side power window) |
C |
A |
FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FIT OR REPLACE PARTS) |
B |
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
C |
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR DTC
HINT:
When using the Techstream with the engine switch off to troubleshoot:
Connect the Techstream to the DLC3 and turn a courtesy light switch on and off
at 1.5-second intervals until communication between the Techstream and vehicle begins.
(a) Connect the ...
Rear Body Side Panel Protector
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR BODY SIDE PANEL PROTECTOR
(a) for Sho ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Hydraulic Brake Booster
*B
for Vacuum Brake Booster
*C
for Automatic Transmission
*D
for Manual Transmission
*1
SKID CONTROL ECU (BRAKE ACT ...