Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.
(e) When depressing or releasing the accelerator pedal, check that the values of Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage are within the specification.
Standard Voltage:
Item |
Condition |
Specified Condition |
---|---|---|
Accelerator Position Sensor No. 1 Voltage |
Released |
0.5 to 1.1 V |
Depressed |
2.6 to 4.5 V |
|
Accelerator Position Sensor No. 2 Voltage |
Released |
1.2 to 2.0 V |
Depressed |
3.4 to 4.75 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY
NOTICE:
This accelerator pedal sensor assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
(a) Install the accelerator pedal sensor assembly to the vehicle body with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
NOTICE:
(b) Connect the connector to the accelerator pedal sensor assembly.
Removal
REMOVAL
PROCEDURE
1. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY
NOTICE:
This accelerator pedal sensor assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
(a) Disconnect the connector from the accelerator pedal sensor assembly. |
|
(b) Remove the 2 bolts and accelerator pedal sensor assembly from the vehicle body.
Removal
REMOVAL
CAUTION / NOTICE / HINT
Text in Illustration
*a
Object Exceeding Weight Limit of Transmission Jack
Be sure to perform this procedure with several people as the rear differential
carrier assembly is very heavy.
Be sure to follow the procedure ...
Test Mode Procedure
TEST MODE PROCEDURE
1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
(a) When the ignition switch is turned ON, check that the ABS warning, brake
warning, and slip indicator lights come on for approximately 3 seconds.
HINT:
When the brake fluid level is low, the brake warning light c ...
Terminals Of Ecu
TERMINALS OF ECU
1. OCCUPANT DETECTION ECU
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specification
+B (O5-1) -
GND (O5-3)
R - W-B
Battery
Ignition switch on
...