DESCRIPTION
This DTC is stored when items controlled by the Air conditioning amplifier assembly cannot be customized via the navigation system vehicle customization screen.
HINT:
The Air conditioning amplifier assembly controls the air conditioning system related items that are customizable via the navigation receiver assembly screen.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15F5 |
Air conditioning amplifier assembly vehicle setting processing error. |
|
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
OK:
CAN communication DTCs are not output.
NG |
GO TO CAN COMMUNICATION SYSTEM |
|
2. |
CHECK AIR CONDITIONING SYSTEM |
(a) Check if the air conditioning system is malfunctioning (See page ).
HINT:
Customization may not be possible depending on the malfunction in the air conditioning system.
OK:
No malfunctions are present in the air conditioning system.
NG |
GO TO AIR CONDITIONING SYSTEM |
|
3. |
CHECK CUSTOMIZE ITEMS |
(a) Display the "Vehicle Customization" screen.
(b) Make a note of the customizable items for the air conditioning system.
HINT:
These air conditioning system items shown as customizable via the navigation receiver assembly vehicle customization screen can also be changed using the Techstream. In the following steps, the Techstream will be used.
(1) To match-up the items in the navigation receiver assembly with the items on the Techstream, check the customize parameters list for the air conditioning system related items that can be customized via the navigation receiver assembly screen (See page ).
(c) Using the Techstream, confirm that it is possible to change the settings of the air conditioning system related customize parameters that are shown as customizable via the navigation receiver assembly screen.
OK:
The items available for customization via the navigation receiver assembly screen can be customized successfully using the Techstream.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
Replacement
REPLACEMENT
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
(a) Start up the engine.
(b) Turn the A/C switch to ON.
(c) Operate the cooler compressor with an engine speed of approximately 1,000
rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil
rem ...
Short in Side Squib LH Circuit (B1825/56-B1828/56)
DESCRIPTION
The side squib LH circuit consists of the airbag sensor assembly and the front
seat airbag assembly LH.
This circuit signals the SRS to deploy when airbag deployment conditions are
met.
These DTCs are set when a malfunction is detected in the side squib LH circuit.
DTC ...
Disassembly
DISASSEMBLY
PROCEDURE
1. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
(a) Check the spider bearings for wear and damage.
(b) Check each spider bearings axial play by turning the yoke while holding the
shaft tightly.
Maximum bearing axial play:
0 to 0.05 mm (0 to 0.00197 in.)
If t ...