TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Vf2cm Transfer / Transfer Case Rear Oil Seal

Toyota Tacoma (2015-2018) Service Manual: Transfer Case Rear Oil Seal

Components

COMPONENTS

ILLUSTRATION

Replacement

Replacement

REPLACEMENT

PROCEDURE

1. DRAIN TRANSFER OIL

2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(See page 3. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY )

3. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

(a) Using SST, remove the transfer extension housing type T oil seal.

SST: 09308-00010

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal and extension housing contact surface.

5. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

(a) Coat the lip of a new transfer extension housing type T oil seal with MP grease.

(b) Using SST and a hammer, install the transfer extension housing type T oil seal as shown in the illustration.

SST: 09631-12090

SST: 09950-60010

09951-00600

SST: 09950-70010

09951-07100

Drive in depth (A):

48.5 to 49.5 mm (1.910 to 1.948 in.)

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal.

6. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(See page 8. ADD TRANSFER OIL )

8. ADD TRANSFER OIL

9. CHECK FOR TRANSFER OIL LEAK

9. CHECK FOR TRANSFER OIL LEAK

    Related Tacoma materials

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE NOTICE: After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System). HINT: Use the table below to help determine the cause of problem symptoms. If ...

    Steering Angle Sensor Zero Point Malfunction (C1290)
    DESCRIPTION The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point. If front wheel alig ...

    Correct driving posture
    Drive in a good posture as follows: Sit upright and well back in the seat. Adjust the position of the seat forward or backward to ensure the pedals can be reached and easily depressed to the extent required. Adjust the seatback so that the controls are easily operable. Adjust the t ...