TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Other System / Wireless Charging System / Terminals Of Ecu

Toyota Tacoma (2015-2018) Service Manual: Terminals Of Ecu

TERMINALS OF ECU

1. MOBILE WIRELESS CHARGER CRADLE ASSEMBLY

Tester Connection

Wiring Color

Terminal Description

Condition

Specified Condition

M5-1 (ACC) - M5-5 (PGND)

GR - W-B

Power source (ACC)

Ignition Switch ON (ACC)

11 to 14 V

Ignition Switch off

Below 1 V

M5-5 (PGND) - Body ground

W-B - Body ground

Ground

Always

Below 1 V

M5-9 (TAIL) - M5-5 (PGND)

G - W-B

Illumination signal

Light control switch off

Below 1 V

Light control switch in tail or head position

11 to 14 V

M5-10 (DIS) - Body ground

Y - Body ground

Smart key system status signal

For 1500 ms after turning ignition switch from off to on (IG)*1

4.4 to 6.5 V

Being charged

Below 1 V

Charging suspended due to smart key system status*2

4.4 to 6.5 V
  • *1: The mobile wireless charger cradle assembly checks the status signal for 1500 ms when the ignition switch is turned from off to on (IG). If a status signal voltage of less than 1 V continues for 400 ms or more during the check, the mobile wireless charger cradle assembly judges that the status signal is interrupted, blinks the indicators and stops the operation until the ignition switch is turned off then on (IG) again.
  • *2: For the status of the smart key system when charging is stopped temporarily, refer to System Description (See page ).
    Related Tacoma materials

    On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT AXLE HUB BEARING (a) Remove the front wheel. (b) for 4WD: (1) Remove the front axle hub grease cap (See page ). (c) Remove the front disc brake caliper (See page ). (d) Remove the front disc. (e) Inspect the axle hub backlash. (1) Usi ...

    Precaution
    PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engin ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may ...