TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Seat Belt / Rear Seat Inner Belt Assembly(for Double Cab)

Toyota Tacoma (2015-2018) Service Manual: Rear Seat Inner Belt Assembly(for Double Cab)

Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR SEAT INNER BELT ASSEMBLY

(a) for LH Side:

(1) Install the rear seat inner belt assembly with the bolt.

Text in Illustration

*a

Protruding Part

*b

40°

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

NOTICE:

  • Make sure that the rear seat inner belt assembly is oriented in the correct direction when installing.
  • Do not allow the anchor part of the rear seat inner belt assembly to overlap the protruding part of the floor panel.

(b) for RH Side:

(1) Connect the rear seat inner belt assembly and rear center seat outer belt assembly by installing the floor anchor with the bolt.

Text in Illustration

*a

Protruding Part

*b

40°

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

NOTICE:

  • Make sure that the rear seat inner belt assembly and rear center seat outer belt assembly is oriented in the correct direction when installing.
  • Do not allow the anchor part of the rear seat inner belt assembly and rear center seat outer belt assembly to overlap the protruding part of the floor panel.

Removal

REMOVAL

PROCEDURE

1. REMOVE REAR SEAT INNER BELT ASSEMBLY

(a) for LH Side:

(1) Remove the bolt and rear seat inner belt assembly.

(b) for RH Side:

(1) Remove the bolt and rear seat inner belt assembly.
    Related Tacoma materials

    Short in Side Squib LH Circuit (B1825/56-B1828/56)
    DESCRIPTION The side squib LH circuit consists of the airbag sensor assembly and the front seat airbag assembly LH. This circuit signals the SRS to deploy when airbag deployment conditions are met. These DTCs are set when a malfunction is detected in the side squib LH circuit. DTC ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE Charging System Symptom Suspected Area See page Charging System Warning Displayed Battery Generator assembly Charging system (ON-VEHICLE INSPECTION) ...

    Engine Coolant Temperature Receiver Gauge Malfunction
    DESCRIPTION In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM. WIRING DIAGRAM CAUTION / NOTIC ...