TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Tire And Wheel / Tire Pressure Warning System / Problem Symptoms Table

Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Tire Pressure Warning System

Symptom

Suspected Area

See page

Tire pressure warning light does not illuminate despite tire pressure decreasing

Initialization

Check Data List (ID Tire Inflation Pressure)

ID code check (Registration)

Tire pressure warning light remains illuminated (Goes off during initial check)

Tire pressure warning light circuit

Tire pressure warning light remains illuminated (Illuminates during initial check)

Check Data List (ID Tire Inflation Pressure)

Tire pressure adjustment

ID code check (Registration)

Initialization

Initialization cannot be done

Tire pressure warning reset switch

DTC check cannot be done using SST check wire

TC and CG terminal circuit

ECU power source circuit

Tire position not identified*

Tire pressure warning valve and transmitter

Main body ECU (Multiplex network body ECU)

-
  • *: w/ Tire Inflation Pressure Display Function
    Related Tacoma materials

    System Description
    SYSTEM DESCRIPTION 1. GENERAL (a) This system uses ultrasonic sensors to detect any obstacles at the corners and the rear of the vehicle. The system then informs the driver of the distance between the sensors and an obstacle as well as their positions by indicating them on the multi-informat ...

    Central Gateway ECU Communication Stop Mode
    DESCRIPTION Detection Item Symptom Trouble Area Central Gateway ECU Communication Stop Mode Communication system DTCs (DTCs that start with U) that correspond to "Central Gateway ECU Communication Stop Mode" in "DTC Com ...

    On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the fins of the cooler condenser assembly are dirty, clean them with water and dry them with compressed air. NOTICE: Do not damage the fins of the condenser assembly. (b) If the fins of the cooler condenser assembly ...