Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Precaution

PRECAUTION

1. IGNITION SWITCH EXPRESSIONS

(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch off

LOCK

Off (Lock)

Ignition Switch ACC

ACC

On (ACC)

Ignition Switch ON

ON (IG)

On (IG)

Engine Start

START

On (Start)

2. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with sharp metal objects, such as safety pins because:

(1) the washer nozzle tip is made of resin and could be damaged.

(2) adjustment is not necessary because it has a spray type nozzle.

(b) If the washer nozzle is clogged with materials such as wax, remove the objects and clean the nozzle hole with a soft resin brush, etc.

Parts Location
PARTS LOCATION ILLUSTRATION ...

System Diagram
SYSTEM DIAGRAM 1. FRONT WIPER AND WASHER SYSTEM 2. WASHER FLUID LEVEL WARNING SYSTEM ...

Other materials:

Removal
REMOVAL PROCEDURE 1. TABLE OF BOLT, SCREW AND NUT HINT: All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabetic codes in the table below. 2. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be requ ...

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT 3RD GEAR THRUST CLEARANCE (a) Using a dial indicator, measure the 3rd gear thrust clearance. Standard clearance: 0.200 to 0.490 mm (0.0079 to 0.0192 in.) If the clearance is outside the specification, replace the 3rd gear, thrust washer, c ...

Removal
REMOVAL PROCEDURE 1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY (See page ) 2. DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY (a) Disengage the 2 clamps. (b) Disconnect the No. 2 fuel tube sub-assembly from the fuel tube sub-assembly (See page ). ...

В© 2011-2026 Copyright www.ttguide.net