Toyota Tacoma (2015-2018) Service Manual: Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
(a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition switch off |
LOCK |
Off |
|
Ignition switch ON |
ON |
On (IG) |
|
Ignition switch ACC |
ACC |
On (ACC) |
|
Engine Start |
START |
Start |
2. POWER WINDOW CONTROL SYSTEM PRECAUTIONS
CAUTION:
- The power window control system uses the LIN communication system. Inspect
the communication function by following How to Proceed with Troubleshooting.
Troubleshoot the power window control system after confirming that the communication
system is functioning properly (See page
.gif)
). - The power window control system prohibits the auto up and down function when the jam protection function malfunctions.
- The power window control system prohibits the auto up and down function when the catch protection function malfunctions.
- If the power window regulator motor assembly has been replaced with
a new one, initialize the power window control system (See page
).
- If the power window regulator motor assembly and door window regulator
sub-assembly have been removed and installed, or if the power window regulator
motor assembly was reused when a door glass or door glass run was replaced,
initialize the power window control system (See page
).
- The jam protection function and the catch protection function may operate
unexpectedly, even when the power window control system is normal, due to
detection of a value different than the operation learned value when the
door glass moving speed changes sharply under any of the following conditions:
- A power window is being opened or closed while the vehicle is driven on a rough road.
- A power window is being opened or closed while the door is being opened or closed.
- The voltage changes abruptly.
- Do not disconnect the battery while the ignition switch is ON. Otherwise,
DTC B2313 will be stored (See page ).
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Double Cab
*B
for Access Cab
*C
w/ Back Door Power Window
-
-
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the power window control
system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE ...
Other materials:
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
If one of the camshaft timing gear bolts is already removed, do not remove any
other camshaft timing gear bolts.
PROCEDURE
1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. REMOVE ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL RADIATOR GRILLE
(a) Engage the 10 guides to install the radiator grille.
(b) Install the 2 clips.
(c) Install the 2 screws.
(d) Remove the protective tape.
(e) w/ Toyota Safety Sense P
(1) Engage the clamp.
(2) Connect the connector.
2. ADJUST MILLIMETER W ...
Short in Side Squib RH Circuit (B1820/55-B1823/55)
DESCRIPTION
The side squib RH circuit consists of the airbag sensor assembly and the front
seat airbag assembly RH.
The circuit signals the SRS to deploy when airbag deployment conditions are met.
These DTCs are set when a malfunction is detected in the side squib RH circuit.
DTC No ...
