DESCRIPTION
The combination meter communicates with the ECM, skid control ECU, power steering ECU, main body ECU (multiplex network body ECU), airbag sensor assembly, navigation receiver assembly*1, radio and display receiver assembly*2, Forward recognition camera*3 and Millimeter wave radar sensor assembly*3 via the CAN communication system.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
U0100 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U0129 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U0142 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U0151 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U0163 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U023A |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
|
U1104 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
- *1: for Navigation Receiver Type
- *2: for Radio and Display Type
- *3: w/ Toyota Safety Sense P
- *4: for Vacuum Booster Type
- *5: for Hydraulic Booster Type
PROCEDURE
|
1. |
CONFIRM DTC OUTPUT |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
(e) Clear DTCs.
See page .gif)
(f) Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
(g) Stop the vehicle.
(h) Check DTCs.
See page
|
Result |
Proceed to |
|---|---|
|
DTC is output |
A |
|
DTC is not output |
B |
HINT:
If CAN communication system DTC U0100, U0129, U0142, U0151, U0163, U023A or U1104 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0142, U0151, U0163, U023A or U1104 first.
| A | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
| B | |
USE SIMULATION METHOD TO CHECK |
