Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

Toyota Tacoma (2015-2018) Service Manual / Mirror / Power Mirror Control System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the power mirror control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

HINT:

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference.
Past problems that seem unrelated may also help in some cases.

The following 5 items are important points in the problem analysis:

What	Vehicle model, system name
When	Date, time, occurrence frequency
Where	Road conditions
Under what conditions?	Running conditions, driving conditions, weather conditions
How did it happen?	Problem symptoms

3.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO STEP 6

5.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check

Click here (b) Data List / Active Test

(b) Data List / Active Test

Click here (c) Terminals of ECU

Click here

6.	REPAIR OR REPLACE

7.	CONFIRMATION TEST

END

Precaution

PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are u ...

System Description

SYSTEM DESCRIPTION 1. FUNCTION OF MAIN COMPONENTS Component Function Vertical mirror motor Moves the mirror surface vertically in accordance with th ...

Other materials:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be then read. (b) ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line *1: for Vacuum Brake Booster *2: for Hydraulic Brake Booster Millimeter Wave Radar Sensor Assembly Forward Recognition Camera ...

Brake Warning Light Remains ON
DESCRIPTION The BRAKE warning light comes on when brake fluid is insufficient, the parking brake is applied or the EBD is defective. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page ...