CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the manual transaxle system.
*: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section.
Click here .gif)
|
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
HINT:
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
|
4. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
HINT:
- Refer to CAN Bus Check in CAN Communication System.
Click here
- The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communications system.
|
Result |
Proceed to |
|---|---|
|
CAN communication system DTCs are not output. |
A |
|
CAN communication system DTCs are output. |
B |
| B | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
|
|
5. |
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
(a) Refer to DTC Check/Clear.
Click here
|
|
6. |
SELECT CHECK MODE DIAGNOSIS* |
(a) Refer to Check Mode Procedure.
Click here
|
|
7. |
CHECK FOR DTC* |
(a) Proceed to DTC Check/Clear.
Click here
|
Result |
Proceed to |
|---|---|
|
DTCs are not output. |
A |
|
DTCs are output. |
B |
| B | |
GO TO STEP 12 |
|
|
8. |
SYMPTOM SIMULATION |
(a) Refer to Symptom Simulation.
Click here
|
|
9. |
COMPONENT INSPECTION |
|
|
10. |
REPAIR OR REPLACE |
|
|
11. |
CONFIRMATION TEST |
| NEXT | |
END |
|
12. |
DIAGNOSTIC TROUBLE CODE CHART |
(a) Proceed to Diagnostic Trouble Code Chart.
Click here
|
|
13. |
CIRCUIT INSPECTION* |
|
|
14. |
IDENTIFICATION OF PROBLEM |
|
|
15. |
REPAIR OR REPLACE |
|
|
16. |
CONFIRMATION TEST |
| NEXT | |
END |
