TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Pre-collision / Pre-collision System / Front Camera Module Beam Axis Not Adjusted (C1AA9)

Toyota Tacoma (2015-2018) Service Manual: Front Camera Module Beam Axis Not Adjusted (C1AA9)

DESCRIPTION

If forward recognition camera adjustment has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, DTC C1AA9 will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AA9

Front Camera Module Beam Axis Not Adjusted

The millimeter wave radar sensor assembly detects that forward recognition camera adjustment has not been completed for 1 second or more.

Forward recognition camera system

PROCEDURE

1.

GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AA9 is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

NEXT

END
    Related Tacoma materials

    Reservoir Level Switch Disconnected (C1453,C1454)
    DESCRIPTION The brake fluid level warning switch sends the appropriate signal to the skid control ECU (master cylinder solenoid) when the brake fluid level drops. DTC Code DTC Detection Condition Trouble Area C1453 With the ECU termina ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL NO. 3 REAR BODY NAME PLATE (for 2GR-FKS) 2. INSTALL NO. 2 REAR BODY NAME PLATE (for 4WD) 3. INSTALL SIDE GATE SUPPORT FEMALE HINGE RH (a) Engage the claw to install the side gate support female hinge RH. ...

    Precaution
    PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...