TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Meter / Gauge / Display / Meter / Gauge System / Customize Parameters

Toyota Tacoma (2015-2018) Service Manual: Customize Parameters

CUSTOMIZE PARAMETERS

1. CUSTOMIZE METER / GAUGE SYSTEM

(a) Customizing with the Techstream

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Warning or Display.

(5) Select the setting by referring to the table below.

NOTICE:

Record the current settings before customizing.

Warning

Display

Default

Content

Setting

Relevant ECU

Key Remind Volume

Large

Function to change the volume of the key reminder buzzer.

Large,Medium,Small

Combination meter assembly

Key Remind Sound

Normal

Function to change the frequency of the key reminder buzzer.

Normal,Slow,Fast

Combination meter assembly
Display

Display

Default

Content

Setting

Relevant ECU

ODO Display Time After IG OFF Setting

30s

Function to change the ODO Display Time After IG OFF Setting.

30s,60s,600s,OFF

Combination meter assembly
    Related Tacoma materials

    System Description
    SYSTEM DESCRIPTION 1. GENERAL (a) The blind spot monitor system has the blind spot monitor function and rear cross traffic alert function. (1) Blind spot monitor function The blind spot monitor function is a function that assists the driver in making the decision to change lanes. Th ...

    Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the "See page" given. *1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates. *2: "DTC stored" means ...

    System Diagram
    SYSTEM DIAGRAM Transmitting ECU (Transmitter) Receiving ECU Signal Communication Method Skid control ECU (Brake actuator assembly) Steering angle sensor (Spiral cable with sensor sub-assembly) Steering angl ...