TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Intuitive Parking Assist System / Clearance Warning ECU Power Source Circuit

Toyota Tacoma (2015-2018) Service Manual: Clearance Warning ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)

(a) Disconnect the C30 connector from the clearance warning ECU assembly.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

C30-1 (IG) - Body ground

Ignition switch ON

11 to 14 V

C30-1 (IG) - Body ground

Ignition switch off

Below 1 V
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

2.

CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

C30-30 (E) - Body ground

Always

Below 1 Ω
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Related Tacoma materials

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT SUSPENSION LOWER ARM (a) Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on ...

    Vehicle Stuck: Recovery Procedures
    If the Toyota Tacoma becomes stuck in mud, loose dirt, sand, or snow and the drive wheels begin spinning without moving the vehicle, use the following recovery procedure carefully to regain traction. Recovering procedure 1. Stop the engine, apply the parking brake securely, and move the shift lever ...

    Initialization
    INITIALIZATION NOTICE: Initialization can only be performed for vehicles with a tire pressure warning reset switch. If initialization is performed, the existing tire positions will be cleared, but will be automatically identified when the vehicle is driven at 37 km/h (23 mp ...