Toyota Tacoma 2015-2018 Service Manual: Vehicle Control History

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the "See page" given. *1: "Comes on&qu ...

Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)

DESCRIPTION Refer to the system description for DTC P2714 (See page ). DTC No. DTC Detection Condition Trouble Area P2716 Open or short ...

Other materials:

Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION The No. 1 ATF temperature sensor converts the fluid temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature becomes hi ...

Vehicle Position Mark Deviates Greatly
CAUTION / NOTICE / HINT NOTICE: If standard size tires are not installed, the vehicle position mark may deviate from the route even if the navigation system is operating normally. Make sure that standard size tires are installed to the vehicle before inspection. PROCE ...

Clutch Pedal Switch
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK CLUTCH START SYSTEM (a) Check that the engine does not start when the clutch pedal is released. (b) Check that the engine starts when the clutch pedal is fully depressed. If necessary, replace the clutch start switch assembly. ...