Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Propeller Shaft Assembly(for 4wd)

Toyota Tacoma 2015-2018 Service Manual / Propeller Shaft / Propeller Shaft Assembly(for 4wd)

Reassembly
REASSEMBLY PROCEDURE 1. INSPECT CENTER NO. 2 SUPPORT BEARING ASSEMBLY (a) When turning the center No. 2 support bearing assembly with your hand, check that it turns smoothly without catching an ...

Components
COMPONENTS ILLUSTRATION ...

Other materials:

Taillight Relay Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. If the main body EC ...

Check Bus 5 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be then read. (b) ...

В© 2011-2020 Copyright www.ttguide.net