PRECAUTION
1. PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the DLC3, and turn a courtesy light switch on and off at 1.5 second or less intervals until communication between the Techstream and vehicle begins.
(b) After all DTCs are cleared, check if the trouble occurs again 6 seconds after turning the engine switch on (IG).
2. PRECAUTION FOR REGISTRATION
(a) If replacing any of the following parts, refer to the registration procedures
(See page ).
NOTICE:
Any keys or ECUs for which registration has been performed cannot be reused.
(1) Certification ECU (smart key ECU assembly)
(2) Steering lock ECU (steering lock actuator or upr bracket assembly)
(3) Electrical key transmitter sub-assembly
(b) After replacing the steering lock ECU (steering lock actuator or upr bracket assembly), confirm the lock/unlock operation of the steering lock.
Operation
Steering Lock |
Operation Condition |
---|---|
Locks |
With the engine switch off, open and close any door. |
Unlocks |
Turn the engine switch from off to on (ACC) or on (IG). |
3. PRECAUTIONS FOR BATTERY
(a) Immediately after disconnecting and reconnecting the battery cable, the entry unlock function may not operate. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock operation.
(b) When the battery is discharged, if the battery of another vehicle is used to jump start the engine, move the shift lever to P and open and close the driver door with the engine switch off before starting the engine.
(c) After the battery is removed and reinstalled, be sure to wait 10 seconds or more before the next engine start. The engine may not start immediately after the battery is reinstalled.
HINT:
Brake
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left
before beginning.
(a) Check all the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning)
(See page )
2. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning)
(See page )
3. CHECK AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning)
(See page )
4. CHECK ...
Radio Receiver Assembly Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Radio Receiver Assembly Communication Stop Mode
Either condition is met:
Communication stop for "Display and Navigation (AVN1)" is indicated
on the "Commun ...