Toyota Tacoma manuals

Toyota Tacoma Owners Manual: Perchlorate Material

Special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.

Your vehicle has components that may contain perchlorate. These components may include airbag, seat belt pretensioners, and wireless remote control batteries.

CAUTION

■General precautions while driving

Driving under the influence: Never drive your vehicle when under the influence of alcohol or drugs that have impaired your ability to operate your vehicle.

Alcohol and certain drugs delay reaction time, impair judgment and reduce coordination, which could lead to an accident that could result in death or serious injury.

Defensive driving: Always drive defensively. Anticipate mistakes that other drivers or pedestrians might make and be ready to avoid accidents.

Driver distraction: Always give your full attention to driving. Anything that distracts the driver, such as adjusting controls, talking on a cellular phone or reading can result in a collision with resulting death or serious injury to you, your occupants or others.

■General precaution regarding children’s safety

Never leave children unattended in the vehicle, and never allow children to have or use the key.

Children may be able to start the vehicle or shift the vehicle into neutral.

There is also a danger that children may injure themselves by playing with the windows, or other features of the vehicle. In addition, heat build-up or extremely cold temperatures inside the vehicle can be fatal to children.

Scrapping of your Toyota
The SRS airbag and seat belt pretensioner devices in your Toyota contain explosive chemicals. If the vehicle is scrapped with the airbags and seat belt pretensioners left as they are, this may cau ...

Symbols used throughout this manual
...

Other materials:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Pre-collision System DTC No. Detection Item Link C1A02 Vehicle Information Not Obtained C1A10 Front Radar Sensor C1A11 Front ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact. PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (w/ Towing Package) (See page ) 2. REMOVE REAR BUMPER ASSEMBLY (w/o Towing Package) (See page ) 3. REMOVE CONN ...

Magnetic Clutch Relay
Inspection INSPECTION PROCEDURE 1. INSPECT MAGNET-CLUTCH RELAY (a) Check the resistance. (1) Using an ohmmeter, measure the resistance between the terminals. Standard: Tester Connection Specified Condition 3 - 5 ...

© 2011-2020 Copyright www.ttguide.net