Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Manual Transmission System|
DTC Code |
Detection Item |
MIL |
Memory |
See page |
|---|---|---|---|---|
|
P03352A |
Crankshaft Position Sensor "A" Signal Stuck in Range |
Does not come on |
DTC stored |
|
|
P033531 |
Crankshaft Position Sensor "A" No Signal |
Does not come on |
DTC stored |
|
|
P050031 |
Vehicle Speed Sensor "A" No Signal |
Does not come on |
DTC stored |
|
|
U010087 |
Lost Communication With ECM/PCM "A" Missing Message |
Does not come on |
DTC stored |
|
.gif)
Dtc Check / Clear
DTC CHECK / CLEAR
HINT:
DTCs which are stored in the ECM can be displayed on the Techstream.
The Techstream can display pending DTCs and current DTCs. Some DTCs
are not stored unl ...
Lost Communication With ECM/PCM "A" Missing Message (U010087)
DESCRIPTION
The engine control unit and transmission control unit are located inside the
ECM. The engine control unit intercommunicates with the transmission control ECU
via CAN communication. If ...
Other materials:
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch
(Position)
...
Unable to Lock Steering Wheel
DESCRIPTION
The steering lock actuator assembly activates the steering lock motor and moves
the lock bar into the steering column to lock the steering.
When the steering lock is operating, the steering may not lock when the lock
bar is not aligned with the lock hole of the steering column. In ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan
tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector
3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be
then read.
(b) ...
